Apartment Manual

After paying for your reservation you will receive a booking confirmation.

On the day of arrival, you will receive a unique code from the entrance door that is valid for the entire duration of your stay with us.

The door will open automatically after entering the code and pressing the picture of the locked lock, please do not push into the door, it takes a while.

Upon request (for longer stays), we can lend you a chip for the apartment's security system.

In addition to coat racks, there is also a heated ladder in the entrance hall, which you can use as needed.

Underfloor heating is installed throughout the apartment with one regulator - under the switchboard.

Due to the slow temperature change of underfloor heating, we recommend reducing the temperature in the early evening, or turning it off at night. You will sleep better and will not be disturbed by the contactor switching the heating according to the thermostat.

The ceiling lighting remote control is on the right by the window behind the entrance to the main room of the apartment.

The light in the bathroom above the mirror is turned on by a touch sensor from the bottom in the middle of the mirror.

The sauna lighting remote control is hung on the front wall of the sauna next to its controls, but it is only active after turning on the sauna

The remote control for the kitchen lighting is located on the kitchen worktop. The hood is switched on by pressing the control button in the middle under the door of the upper left cabinet.

Before leaving the apartment, please hang all remote controls back in their place.

You turn on the sauna with the side switch on the control box. If the sauna light is on, you can change its intensity with the appropriate remote control, not on the sauna panel. There, the left display should be permanently set to 100%.

To turn on the sauna heating, press the middle buttons on the control panel simultaneously. The display will show the letters "On", after pressing again, the heating will be turned off and the display will show the letters "Off".

You can regulate the temperature in the sauna using the right buttons on the sauna control panel. Above these buttons, the display shows the current temperature in the sauna. After pressing the buttons, the set target temperature in the sauna is displayed.

Before filling the bathtub, insert the plug and then fill it with water. Add the included cosmetics to the water as you wish. Please do not use bath salts, as they may damage the surface of the bathtub.

ATTENTION!! - The wooden bathtub does not have an overflow like a regular bathtub. Please be careful when filling the bathtub. Filling the bathtub up to the seats takes approximately 25 minutes, filling the entire bathtub takes approximately 40 minutes.

You start the bubble bath with a button on the panel behind the bathtub on the wall.

If you ordered a keg of beer, it is ready to use and the tap is on. You can turn the tap off or control the cooling power and you can also turn the tap compressor on or off using the buttons on the front of the control panel.  If you finish the keg and no more are available, do not disconnect the tap from the keg.

If you know in advance that you will be change the keg for the next one, please let us show you the procedure.

If you find anything missing from the instructions, please let us know and we will be happy to add it.

Enjoy your stay :)